8e3b0d7cfe
TV cards.
This port contains:
- Drivers for the Conexant MPEG-2 Codec driver which can be found
on the Hauppauge PVR-250/350 TV cards.
These drivers are (c) John Wehle <john@feith.com>
On FreeBSD 4.x, the device used is /dev/bktr0.
On FreeBSD 5.x, the device used is /dev/cxm0
This driver has been successfully tested on:
- FreeBSD 4.10
- FreeBSD 5.2.1
- Two simple programs to modify some ioctls on the card: set the
channel and set the window size.
Note:
- The configuration screen is only applicable for the the Philips
FQ1216M tuner. For other tuners ignore this section. Select just
one entry.
- Note: the maintainer of this port has no inside knowledge of the
workings of this software. Please don't contact me about cards
which don't work. Please contact me about problems with the port,
with possible enhancements, with success stories.
Author: John Wehle <john@feith.com>
Submitted by: edwin@mavetju.org
30 lines
991 B
Plaintext
30 lines
991 B
Plaintext
PVR-250/350 - Nearly done!
|
|
|
|
If you haven't patched /usr/src/sys/dev/iicbus/iicbb.c yet, and
|
|
rebuild a new kernel, and rebooted, these are the following steps:
|
|
|
|
- Run "make patch-iicbb". This will enable cxm to use the i2c bus.
|
|
- Add this to your kernel configuration file:
|
|
DEVICE iicbus
|
|
DEVICE iicbb
|
|
- Rebuild your kernel.
|
|
- Reboot.
|
|
|
|
Next step is to load the drivers:
|
|
- Run "kldload cxm_iic"
|
|
- Run "kldload cxm"
|
|
|
|
Check your console (or /var/log/messages if you're running X) and
|
|
you should see something like:
|
|
|
|
cxm0: <Conexant iTVC15 MPEG Coder> mem ... irq ... at device ... on pci ...
|
|
cxm_iic0: <Conexant iTVC15 / iTVC16 I2C cnotroller> on cxm0
|
|
iicbb0: <I2C bit-banging driver> on cxm_iic0
|
|
cxm0: Philips FI1236M K2 Tuner
|
|
cxm0: SAA7115 rev 1 video decoder
|
|
cxm0: MSP3435G-B6 audio decoder
|
|
cxm0: IR Remote
|
|
|
|
To test the card, either do "cat /dev/bktr0 > filename.mpg" (FreeBSD
|
|
4.x) or "cat /dev/cxm0 > filename.mpg" (FreeBSD 5.x).
|