XFree86 (3 or 4) to depend to when USE_XLIB is set.
XFREE86_VERSION defaults to 3 for now, but adventurous users can
override it in /etc/make.conf. When XFREE86_VERSION=3, USE_XLIB
will add a dependency to x11/XFree86; when it is set to 4, the
dependency will be to x11/XFree86-4-libraries. When
XFREE86_VERSION=4, the PKG_IGNORE_DEPENDS and ALWAYS_BUILD_DEPENDS
hacks to avoid messing with XFree86 are turned off.
Since XFree86 version 4 includes some software that used to be
separate ports, when XFREE86_VERSION=3 the following variables are
provided:
USE_DGS LIB_DEPENDS on x11/dgs
USE_FREETYPE LIB_DEPENDS on print/freetype
USE_MESA LIB_DEPENDS on graphics/Mesa3
USE_XPM LIB_DEPENDS on graphics/xpm
When XFREE86_VERSION=4, these variables have no effect. The
LIB_DEPENDS in the tree for the above four ports have all been
converted to the USE_* counterparts. For your information, this
is the count of the number of ports:
USE_DGS 0
USE_FREETYPE 16
USE_MESA 36
USE_XPM 236
There is a new variable, XAWVER, which is set to 6 when
XFREE86_VERSION=3 and 7 when XFREE86_VERSION=4. This is also
passed to PLIST_SUB so ports that build Xaw based shared libraries
can use this variable to substitute the shlib version number.
There is also a provision of using a separate mtree file for
XFREE86_VERSION=4, but that part is not enabled yet.
Reviewed by: the ports list
Tested by: make index (XFREE86_VERSION=3 only)
(2) Add hebrew to list of valid categories.
Submitted by: nbm
From the Home Page: The only changes from version 1.0b.0 are
XFace support and a few bug fixes. XFace support isn't enabled
in the port, didn't have the time and need.
installs the version of the port that uses shared library number 9 and the
LIBRARY_VERSION set to the default. Normally this is against our policy
(bumping the version number for minor things), however due to the major
problems caused with the upgrade, Satoshi and I decided that this was best.
Approved by: asami
port dependency to jpeg an png lib, because inline imaging is enabled now
the pre-configure script edits knews.tmpl after it has been patched
enable automatic jump into threaded mode in Knews.ad
port dependency to mp port, because default print command now uses newsp
(1) Add $Id$.
(2) Reorder variables. Remove unnecessary PKGNAME (was ==DISTNAME).
(3) Remove spurious comments about MAINTAINER, it's funny to if you
look at the diff between 0.9.5 and 0.9.6 though.
(4) Remove unnecessary "IS_INTERACTIVE=no", that is a binary (set/unset)
variable so it actually meant "yes" (and I'm sure that's not what
Andreas meant).
